Front and Rear measurements

IDRVSLO

Goblin Guru
Can someone who has either done an alignment or has done the initial settings measure the distance from the starting point on the threads to the starting point on the tie rod end?

Just want to get a close baseline before installing.

Rear
20181208_124853.jpg


Front
20181208_124818.jpg
 

IDRVSLO

Goblin Guru
Just measured my front. Currently it is less than an inch on both sides and my tires are fairly toed in. That is eyeballing it but it's pretty noticeable.
 

Nilbog

Well-Known Member
Did you move the stock tie rods off the R&P and put them on the rear? Then install the supplied tie rod ends on the front?
 
Top