Fozda
Goblin Guru
Someone's serious about winning!Driver's seat showed up today.
Someone's serious about winning!Driver's seat showed up today.
Either that or I'm really tallSomeone's serious about winning!
No, nothing on this end.Any word from shippers?
Probably stock.She’s mighty purty. What clutch/flywheel you thinking of using?
Talked to Adam today. He said they are likely going to be to AZ either end of next week or beginning of the following week.No, nothing on this end.
Thanks for the update. I guess I had better get to selling all these parts. I don't have room lol.Talked to Adam today. He said they are likely going to be to AZ either end of next week or beginning of the following week.
I purchased same in November. Delivered in 3 days. Hope to have it installed in a few weeks.Well I bit the bullet and just ordered a new ATK longblock.
GM 2.0 Ecotec Complete Engine
ATK 20LNF1 GM 2.0 Ecotec Complete Engine , Call 866-721-2315 to Speak with an ATK Crate Engine Specialistwww.high-performance-engines.com
I figure a 67k mile longblock should be be able to recoup almost half of the cost. After seeing Desert Sasquatch's new ATK motor it's just too good of a deal to pass up.
Looking good! Are you doing the emergency brake on yours? Don’t throw any of your ebrake parts out like me.I made some good progress this week. I got most of the stuff I don't need off of the car and sold. Except for the doors which is a shame because they are in great shape.
Next I will start taking out the stuff I need since I have a little space again.
View attachment 20066View attachment 20067View attachment 20068View attachment 20069View attachment 20070
Do they work on button head cap screws?Just an FYI to anyone who hasn't discovered these but they are amazing. I have yet to find a stripped bolt head that they can't remove. A must have tool IMO.
I haven't tried it but if there's enough metal for it to grab onto then it probably would. You can pound them on with a hammer if it's perfectly round and it will cut grooves in the bolt to hold it. There are imported knock-offs available for less than half the price that also seem to work really well.Do they work on button head cap screws?
I ordered a couple of cans of Steel-It to try out. I like the idea that you can weld through it and touch up the frame easily.So good to get that call. Excited to see your progress. Are you powdercoating your frame?