Thanks. Knowing this is how it’s supposed to install is helpful. I first assumed that but could not get it in thay way either lol. So that’s when I figured I was doing something wrong and I needed to push it in the way it came out. Yes I noticed the two alignment notches from the start so was...
thanks but I’m fairly sure I’m doing everything right and it’s not like it’s rocket science. I’ve built entire cars and engines and bikes etc so this has me feeling like quite a fool lol. I’m not sure if the elbow base is slightly warped maybe previous owner played around with it on install...
Sooo please tell me I’m doing something wrong. I have spent the last hour and a half literally trying to get the clip back into the clutch elbow. I have tried every angle and tool and method. Everything works as it should separated but it just won’t go any further than half way. What should be a...
yeah that I know I just haven’t put back the wires yet they are all in a heap so gotta figure that one out and I’m guessing it won’t reach it if it’s on the other side. I’ll just have find the correct ground and work from there.
Hi all so trying to get this thing fully put back up to go for a drive and see what’s what but can’t remember the exact location for this bolt / stud with the ground thread extension. Thought I had a pic but can’t find it. Can anyone confirm this is the right bolt hole for it right behind the...
Sigh I hope not either. I have another engine there to build so I will probably be back at it at some point. I have to reconnect everything during the course of this week, bleed brakes and clutch and fill coolants and then go for a drive and hope that everything works as it should. I have gear...
To bolt it all back I’m going to lift the engine with the hoist, slide the subframe under onto 4 jacks stands then bolt the engine back onto the subframe and transfer the hoist onto the chassis and drop that back down onto the engine and bolt it back to that and the subframe. Then I have to...
Thanks. Started last night and did more than was necessary but more or less figured out what you just said would be the best way next time. I ended up using my bike jack to actually line up the gearbox and that worked well. Freaked out at first cause the fidanaza flywheel wasn’t lining up with...
Hi all, purchased my Goblin assembled so never had the joy / pain of putting it altogether but I have a brand new 0 mile LSD gearbox for my LSJ and stage 2 clutch (current one is beginning to slip anyway) to install and wondering for all who have done this what the best process is, how involved...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.