Spague's latest activity
-
SSpague replied to the thread Goblin "ABS Emulator" - disable ABS, traction control and brake warning lights.Ordered. Thank you for your continued support of the Goblin community.
-
SThis week's Goblin of the Week was built by Nick Brown from Troy, Michigan. After Nick had purchased his donor and was planning his...
-
SGot the front splitter installed. Mostly did it the same way as Rttoys. For my front attachment I drilled two holes in the two bottom...
-
SSpague reacted to ctuinstra's post in the thread Custom STL Files for 3D Printed Goblin Parts with
Like.
MM -
SSpague replied to the thread Custom STL Files for 3D Printed Goblin Parts.If I were to have one of these printed is the measurement in MM or SAE?
-
Shttps://www.instagram.com/reel/C4Lzn_OpItR/?igsh=MXhlc2h6YnN3dmVvZg== Started production on the splitters! Looking forward to getting...
-
SThat's it for now. Using the stock ignition barrel, I can start the car with the transponder ring completely unplugged, which I presume...
-
SCan people post how they mount theirs once they get them.
-
SSpague replied to the thread Goblin Front Splitter Group buy.I would like a non - intercooler version please
-
SLooks like there are more of these I am going to make then I expected. Wanted to bring up one fitment issue I know of, and at the rear...
-
SI didn't get those parts in my goblin kit, but they look like alignment washers for hiem joints.