Search results

Son of a... so for texas you need the parking brake, a catalytic converter, both O2 sensors, and the Evap system????? Ah man, this is depressing. I didn't keep the parking brake stuff. What's the Evap system consist of??

Also, what are these and where do they go? Thanks again!!!

Gents, on the rear BC racing coils with the 300 lb springs, 3.5 inch of base lift, and 4 inch spacing between base ring and bottom of ring, should the spring be compressed at all?? Mine need about another 1/3 of an inch to start compressing? I assume once I place the weight of engine down it...

Do I need to use a plate between the rear steering knuckle and the new hub? Should I add some spacers? I remember someone having an issue with bolts rubbing on rotor and cant remember if that was the reason why? Thanks!!!!

Thanks for the quick reply!!!!!!!!

Gents!, Is this the right plate for this tranny or is there some sort of spacer? Can I remove this connecter? I'm pretty sure it went to the second O2 sensor. Thanks!!!!!!!

Sasqwatch, yes thanks!, I flipped them and put the short tie end rods from DF up front and longer ones in back. Jason, I'm not sure. I'll look into it though and see what I have. I got Heat Exchanger in!! I found one of Tom Anderson vids that kinda showed how to do it. Does the red wire...

Sasqwatch! Absolutely!! I hit a rough spot getting that subframe bolt installed to the engine mount. Took me about 8 hours over three days. I used one of yalls trick with the ratchet strap. I used an industrial air force cargo strap and a cheater bar to tighten it enough where I could...

Scott, you are a gentleman and a scholar. Where did you get this link and are there more? I clicked on the Second Stage photos link from the Assembly discussion and there are only about 20 pics from the orange car. Thanks again!

Steering column shaft install question. Is there something I need to install or tighten in this shaft hole to keep it on? Or do the screws from that round black piece hold it on and if so is there a spacing requirement as where this shaft should fit on the steering shaft? Thanks in...

Thanks so much gents! Y'all rock!

There's supposed to be a cover here correct? Anyone have any idea what it's called or part number? Thanks so much!!!

Few updates. Got it powdercoated by Crosslink in San Antonio and they did an outstanding job. Riveted floor pans in by hand. Will buy a pneumatic tool next time. Rebuilt steering rack. Installed EPS. I'm rust treating and painting the pedal boxes now. I need to buy a tool to bend the...

Jason, I'm in San Antonio, but once it's built, will definitely want to try and meet up with you sometime at an event in Houston. Sasqwatch, I was mostly a KC-10 tanker and T-1A instructor guy. Those were some really great times! Definitely miss it.

Hello fellow Goblinista's! My name is Justin but it looks like there are a few other Justin's as well, so I'll go with my old callsign Jug. This is the first time I've ever attempted a project of this magnitude, so I apologize in advance for some of my questions and overall mechanical...