Search results

Straps are done per the video. Same with the pum0, 1/4" wrench under the ring

The tank is flexing all over. The side is folding and I installed it per the videos. Dont really like the plastic. I'll look into the rubber gasket. It's just to take up space. I know others have had the same issue.

I drove the Goblin all last year and it was fine. Had to change the fuel pump and fuel started leaking out from between the pump housing and the tank. Readjusted and the same. Put a cork gasket in with the o-ring and it stopped for a little bit. Now it's doing it again. Any ideas??? It...

Held on with bungee. Only thing I had to do was shorten them. Haven't noticed and whistle or flapping yet. I think it's worth it!

Back together after the accident and finally wrapped. Shadeidea sun shade works great. I think my tinkering is done for the summer!

Thank you! I searched and those ones did not come up

Anyone have the part number or what vehicle the front tie rod ends are for, outer?

Drive to the Monticello one. It was super easy. Declaration of reconstruction is for the inspection if I remember right and the inspection is after unless you want to trailer it. I drove mine most of last year being registered without inspection. Dan hasn't had his inspected and has been...

I went to the Monticello DMV at the recommendation of another. Was super simple. I didn't fill any of that out. They asked questions and made the process easy. Mine is a convertible, valued at $18000, odometer I had set at something like 1000, and yes it's a kit car. They have a special...

Fan Mounting Kit, Mellbree Electric Radiator Fan Mounting Kit Compatible for Electric Cooling Fan and Transmission Cooler https://a.co/d/6wjwGEg

Definitely, I was stressing there maybe damage to the frame and they'd total it.

Well I got the front tore apart, and had a sigh of relief. Damage was only to the hood, radiator support and radiator.

They should, a little nervous how difficult it could be depending on the adjustor/company. But already trying to figure it out with DF so that's a good start

One taillight done The bad...a coworker backed into it Pushed the hood back, bent the radiator support and I think broke the radiator mounts. Waiting on insurance now.

Saturn Vue half shaft? Please elaborate

Ambient light sensor mount for easy on/off. Uses two 25mm magnets. One is epoxied to the underside of the mount (pic 2) and the other is epoxied to the underside of the hood and is meant to fit inside the recess (pic 3)

If you print without skirt or brim it should fit. Left side I printed face down, 100% infill with support. Right I printed face up .

It's a continuous feed. Really easy to install and I think only about $50 total.

Same here. Torque them down

Corbeau moab with heaters. I used a 4 point harness but the lap has a push button latch like a normal seat belt.