Search results

A/T for sale, works and drives good. Looks good. I can deliver. Interested in trades too, RV, truck camper, Boats/Jetskis, etc. 25,000 CAD, Marine audio sound system hooked up.

yeah I'm selling mine. Where you located?

Has anybody got appraisals on their goblin? Just curious, insurance is asking for an appraisal.

Gonna swap Maf sensor tomorrow. I started up the engine, it was idling rough just before it was a bout to cut out i disconnect the Maf sensor and then it went back into a "regular" idle. I probably should test the connector too

Yes stops running, the engine has a rough idle for a second or two then shuts off. If i let it run without fuse for a bit then put the fuse in it kept running. its the 10 amp EXH fuse, Exhaust emissio=5009&hash=ef82defd6ece4a0d3d390324c7b1fccd']ns.

ill have to see when that happens again. Right now the car runs but i have my 10 amp exhaust fused pulled. If i put it in the engine starts but then cuts out fairly soon. codes i'm getting now P0030 - HO2S Heater Control Circuit – Bank 1 Sensor 1 P0036 - HO2S...

Its been working since I replaced ECM. Some times it takes a couple key turns to turn it on. There was one time it didn't start for a bit, no crank or anything, but i did get it going after 10 minutes. I think their might be some loose pin connectors. But has not created any major set backs yet...

what hardware is required for mounting the windshield?

perfect, thank you!

How do I adjust camber in the rear ?

What kind of side mounts? Could I just take the slider of my stock seats?

what kind of mounts are you using?

Being 6'3 I need some low seats, right now I have stock, and my head is bar level, little scary. Any suggestions?

boom 30 minute key relearn procedure and its cranking! Too late now 1 am to see how long it runs for. Back at it tomorrow to see if the issues are solved. lets go! Thanks for the help so far, much appreciated!

reading your posts with painful jack a while back, seems like he had a similar issue ". So then I replaced the ECM, re-learned the key, and it started right up and ran very well, but had the P0315 error code " I did not do a key relearn, not quite sure what it is, but i will look into that...

Does not even crank now. Everything else works now, fuel guage was not reading, now it is since I switched ECMs.

So, I switched out my ECM with one from the wreckers. Most of my previous engine code are gone. My Throttle is working now. No engine power reduced warning on dash. But car won't start, I get this error code P0315 Crankshaft Position System Variation Not Learned. I have a scanner that can...

How would find a loose connector, and would you tighten it

well ive lost all communication with my tcm, scan tool wont read now. This was an intermittent problem, I thought I sorted it out, but apparently not. I did get the Low reference ground back though.

Fixed my map sensor. Cleared code and it Hasnt come back yet. Looked like a connector issue there. So that is solved for now. Now working on my Throttle Body. I tested the connector on the throttle body it has 5 volt reference. But the Low Reference is not reading. I tested for continuity from...