Search results

  1. ToxicBill

    Transmission drain plug washer

    I was getting ready to refill my transmission fluid and the washer on the drain plug is shot and the fill plug doesn't even have a washer on it. I couldn't find one that truly fit so I ended up boring out a copper washer which I haven't put on yet. Anyone else have any experience or thoughts...
  2. ToxicBill

    Tie rod ends

    I didn't see this specific question addressed anywhere so I wanted to ask it:. Do I put the tie rod ends from the steering rack onto the back and the ones supplied by DF on the front? If it's posted somewhere, I couldn't find it.
  3. ToxicBill

    SC intercooler

    Does anyone have any pictures they can share of their intercooler install with the intercooler in the front? I've got it installed but everything in the front and back seems very tight. Then I installed the subframe and it got even tighter. Also, both my fittings to the front small radiator...
  4. ToxicBill

    Which Uhaul for picking up kit?

    Looks like I can pick up my kit this weekend!! I think I have two main options, either a 9' cargo van or a 10' box truck. Based on mileage and rates, I can save over $200 by using a cargo van. Of course, if the cargo van doesn't work . . . i need the box truck. I'm picking up the entire kit...
  5. ToxicBill

    ZZP Belt

    I ordered the ZZP stock LSJ belt and it did not fit - I can slip the belt on with the tensioner at full extend. Has anyone ordered this in the past and had issues? Everything on my engine is stock and the new belt is longer than the belt I took off...
  6. ToxicBill

    Threadlocker question

    I assume these bolts have threadlocker already applied. Am I correct? Any reason to add anymore? These are the flywheel and clutch plate bolts.
  7. ToxicBill

    SS/SC coil pack cover

    Let me know if anyone has one of these lying around that they wouldn't mind getting rid of.
  8. ToxicBill

    New wiring video - coolant wire

    I was watching the new wiring videos and am on part 4. At the end of that video, it says I should have a pink wire near the fuse box that needs to be extended for the coolant level connector - I don't have that. The coolant level wire is actually green and is connected to the gray/blue BCM...
  9. ToxicBill

    DELETE ME - Coolant level wire

    I was watching the new wiring videos and am on part 4. At the end of that video, it says I should have a pink wire near the fuse box that needs to be extended for the coolant level connector - I don't have that. The coolant level wire is actually green and is connected to the gray/blue BCM...
  10. ToxicBill

    Pinout for dash harness to body harness connector

    Anyone have the pinout information for the connector that connects the body harness to the dash harness?
  11. ToxicBill

    Threadlocker on external engine bolts

    I'm getting ready to put pieces back on my engine (intake/exhaust manifold, fuel rail, alternator, etc). Is there a recommendation to use or not use threadlocker?
  12. ToxicBill

    2007 SS/SC extra connectors

    I'm working on the main body harness and ran into some connectors and other differences from the video. First, I have two of the copper lugs connected via a thin black wire. Should I just cut it in the middle or near one of the lugs? The rear defrost wire connects to a ground lug. I assume I...
  13. ToxicBill

    Engine Cleaning

    If you cleaned your engine prior to installing it in the Goblin? I'm using Simple Green concentrate (3:1 with water) and a brush to clean up the engine and its doing a decent job but I'm looking for get a little more shine out of it - if its there to be had. Any recommendations on particular...
  14. ToxicBill

    Throw out bearing - LSJ

    I need to replace the throw out bearing in my transmission and was going to order this from ZZP. https://zzperformance.com/products/lsj-upgraded-throwout-bearing?variant=12622802976879 The description has this caveat - If your clutch causes the T.O.B. (throw out bearing) to overextend it will...
  15. ToxicBill

    AC Refrigerant

    My Texas/Houston folks, anyone have any contacts for a person or company that would come to my home to recover the R134? Why is it so hard to do the right thing?
  16. ToxicBill

    Bill's Street/Track Goblin - 2007 SS/SC - Chassis #204

    All this started one day when, believe it not, my wife agreed having a "kit car" would be cool. After discussions, she was more referring to replica cars which are much more pricey than what I had in mind. In any case, I started looking more into the Goblin as it was on the cheaper side of...
Top