Search results

My guy said he used just about 4lb with subframe/control arms and a few additional parts like the firewalls. Nuker-

Ugh really sad to hear the outcome of this crash it really caught me off guard when the buyer texted me from an old sale add if my first goblin… Nuker-

Hey All, I was texted these pics from the buyer of this goblin, does anyone know the history of it? Looks like it’s a 2.4l with turbo kit maybe? Nuker-

Closest thing was probably a Ford Mustang GT 500 :P

Well, I unplugged the MAF and its running like a champ. So I guess I have my answer. Nuker-

I have almost 3500 miles on my Z54 running 23PSI it has not had a hickup yet! Nuker-

Same here, I often wonder if the ZFR would spool faster causing more tire spin then I get on the slightly slower Z54. Nuker-

Yeah hoping to do that tomorrow with the laptop, I’ll post the logs as soon as I can. Thanks!

Hey guys, Car was running great just crossed 2k miles on the engine. Parked an hour later fired it up and noticed it sounded different. Sure enough when you step on it it just bogs down. I’m struggling to make 70mph in 4th gear holding WOT. Codes attached. First thing I did was put in 8...

KC Street care takeover is going to be this Sunday May 7th, Anyone else going to be there? Nuker- https://www.facebook.com/events/738050914594543/?paipv=0&eav=AfZ-NqEsmWZK7pPtjSPyqlwNWgczvvY9D6RA7ClWMR6c7zBU2-rxZt-IjoDh81nqNZ8&_rdr

UGH, Powder Coater lost my drivers side upright 5 days before street car takeover! Thankfully called DF and i'm going to overnight a new one. Hope everyone is still alive! Nuker-

Yeah, Like I posted in another thread, My LDK/Z54 and removed balance shafts opal injectors 93 octane did 440hp 411tq. Base line run with "ZZP" canned tune and Z54 was only 336/310. 23PSI. Nuker-

Something is very wrong if you are only getting 240HP with a 2.0 and z54 turbo. That is less than a stock LNF. Nuker-

I would say for a Kit your best bet would be a personal loan, I doubt anyone would give you an auto loan on it. Nuker-

Still doing great, I know it'll blow up one of these days and I'll be "Forced" to forge the internals! Nuker-

Probably only be there 7-9th with wife and I. Nuker-

Gosh I went and inspected it again and I just don't see anything that is bent... Very frustrating. I'll take pics in better light tomorrow. Nuker-

Yep, I already emailed them, I'm going to replace them anyway just to be safe. Thank you! Nuker-

I guess i'll just go ahead and replace the inner/outer tie rods + rod ends, Any real way to check the arms besides taking it off and comparing to the other side? Anything else I should look at for safety? I'm going to go ahead and replace the aluminum pieces to the new ones DF sent to replace...

Hit a chunk of concrete on the road followed by driving up a curb on Saturday night, Nothing appears bent but it did really mess up my alignment, The front driver side wheel that hit the curb is pointing out away from the other side. Was able to drive home and inspected heavily the next day...