.

Robinjo

Goblin Guru
It will, but if your planning to also run an AFR gauge I would recommend having the dual mount 3D printed somewhere. I think Rauq had one that held the AFR, Boost and light sensor. Also, run that wire from your A/C pressure sensor to the front of the car before you button the center console up and put in the seats.
 

Robinjo

Goblin Guru
The do not do that, I do not believe. It would come off your engine harness, unless you sent them that as well?

Here is how to run that line. This is assuming you want to run HP Tuners at some point. If you do not plan to use HP Tuner and make Mo Powa Baby! then disregard this below. I thought I wasn't, then changed my mind less than 2 month later and wish I had run that line....
 
Last edited:
Top