Button Panel Set

Robinjo

Goblin Guru
Anyone have the button panel set that they haven't installed yet? If you would be so kind, could you post a photo of the baggies contents? I need to know the two shank bolts sizes (thread, pitch and length).
 

snirtman

Well-Known Member
Anyone have the button panel set that they haven't installed yet? If you would be so kind, could you post a photo of the baggies contents? I need to know the two shank bolts sizes (thread, pitch and length).
I'd love to, but my button panel set has been on backorder for 8 months and counting...
 

Gtstorey

Goblin Guru
As far as diameter and thread, as long as the nut and bolt match, does it really matter? I'm pretty sure that everything DF supplies that doesn't screw into a Cobalt part is SAE, not metric and I'm pretty sure they supplied 1/4-20 bolts/nuts. As far as length, there is plenty of room behind the panel if you go a little long.
And 6mm bolts are just slightly smaller in diameter than 1/4".
 

Sebnuts

Well-Known Member
They are definitely 1/4-20s. My bags were missing hardware so I had to go buy bolts anyway. I think I still have the bag though and can snap a pic for you tonight after work.
 

Robinjo

Goblin Guru
They are definitely 1/4-20s. My bags were missing hardware so I had to go buy bolts anyway. I think I still have the bag though and can snap a pic for you tonight after work.
That's be great. I need to get slightly longer bolts and knowing what they are already would be great. I could just pull them out and measure but having them beforehand would be easier.
 
Top