Corbeau seat mounts

[AZmoto]

Is there physically room to mount the Corbeau seats lower than where the DF mounts place them? If so, about how much lower could they go?

 

[RouteAbel]

I think you could potentially lower it about an inch. You could maybe get 2 inches if you were to cut off the mount for the submarine belt of the 5 point harness.

 

[RouteAbel]

Sorry, after looking at it again the back of the seat is much lower so maybe only half an inch.

 

[AZmoto]

Thanks for checking that out. Sounds like I'll have to go with Kirkeys.

 

[Rttoys]

Check out Planted technology cobalt seat mounts SB225DR and PA

Planted Technology® SB225DR - Driver Side Seat Bracket with Standard Bolt Pattern

Driver Side Seat Bracket with Standard Bolt Pattern - Part Number SB225DR by Planted Technology. Available in Interior Department at www.carid.com

www.carid.com

Not sure if this helps, but they sit right on the rails of the goblin. direct fit to a cobalt, so direct fit on the goblin.

 

[benjy]

I would say no, there is a rear nub on the seat that almost touches the floor pan

 

[Mayor West]

Check out Planted technology cobalt seat mounts SB225DR and PA

Planted Technology® SB225DR - Driver Side Seat Bracket with Standard Bolt Pattern

Driver Side Seat Bracket with Standard Bolt Pattern - Part Number SB225DR by Planted Technology. Available in Interior Department at www.carid.com

www.carid.com

Not sure if this helps, but they sit right on the rails of the goblin. direct fit to a cobalt, so direct fit on the goblin.

I almost got these for my Braum seats, but the person I was reading up on who bought braums before me said he got these and they didn't work and need a LOT of welding ot make work.

I'm sorta bummed that I didn't go this route because I'd much rather this way of installation rather than my stopsign brackets that I did.

Also those seat mounts are not cheap.