Heat exchanger wire not found

Oldchevyguy

Well-Known Member
If you are using the NACA duct kit the fan is not used. At least that is my understanding
I really do appreciate your responses, but they are a little off the mark from what I am asking.
I am not using NACA ducts. I plan on using the heat exchanger with the fan as supplied.

I need to run a power wire to the fan. It dosent matter if I use a doner wire, or another. Where do I hook it up? This is my question. Thank you.
 

DCMoney

Goblin Guru
I really do appreciate your responses, but they are a little off the mark from what I am asking.
I am not using NACA ducts. I plan on using the heat exchanger with the fan as supplied.

I need to run a power wire to the fan. It dosent matter if I use a doner wire, or another. Where do I hook it up? This is my question. Thank you.
 

Ross

Goblin Guru
Where can I get the same diagrams for the bcm plus ?
log on, and look at AllDataDIY
 

Acewest

Member
Yeah but idk. Finding info on All-data is not really helping. I found what I needed on here. After I bought alldata
 

Karter2026

Goblin Guru
For BCM plugs. it is pretty simple with alldata.
Go to Diagrams>Connector views>Body control Module> then choose C1, C2,C3 or C4 All pin locations and wire colors are listed there
 
Top