Well, the short and honest answer is that I cannot be 100% it will fit until it’s bolted on and the engine is in. The long answer is that the fuel tank isn’t tall enough to reach the manifold. On the supercharged LSJ Goblins, the tank it’s quite tight against the intake manifold but it has the U shaped flow from the supercharger, to the laminova cores, then back up to where the intake actually bolts on and air flow into the head. The Dyemond Fab intake is obviously just a straight shot in and is actually angled slightly upwards. The tank and rear of the roll cage shouldn’t be an issue based on my hours of picture analysis and approximations. Lol.