NACA duct
- Thread starter Markm
- Start date
Desert Sasqwatch
Bigfoot Goblin
How would you make the NACA duct to heat exchanger plenum to disconnect and reconnect? Would be awkward at best, unless you fab up an angled face plate with a foam seal for the plenum and duct to join when the hood is closed.
And I've seen a few builders mount the NACA ducts to the inside of the hood too. Troll around some builders logs to search for 'NACA'.
And I've seen a few builders mount the NACA ducts to the inside of the hood too. Troll around some builders logs to search for 'NACA'.
Last edited:
Markm
Well-Known Member
The angled flange is what I was thinking also. I have trolled around and found the ducts mounted on the inside and the wife likes that clean slick look. Now to think what to make flanges from
Markm
Well-Known Member
And the side pods look great too
SmsDetroit
Goblin Guru
I glassed in studs inside and then body worked the opening for a smooth finish 
Attachments
Desert Sasqwatch
Bigfoot Goblin
Mark, did you ever get your NACA ducts installed? Did you configure them to work with a hinged hood? Just curious to see what you came up with? It's been a while since we're asking questions about this. 
Markm
Well-Known Member
I haven’t had a lot of time to work on it just yet, I’ve been super busy with regular work but hopefully I’ll get back on it in a couple weeks. I need to get the wife goblin ready for goblinfestMark, did you ever get your NACA ducts installed? Did you configure them to work with a hinged hood? Just curious to see what you came up with? It's been a while since we're asking questions about this.