I have a small but if confusion but I think I've figured it out.
After labeling and cutting my wires from the dash side of the dash to body connector, I have 5 wires and a pair of twisted data lines.
From reading other posts, it sounds like I need to connect these twisted data wires to those I extended from the ECM to complete the daisy-chain. I do not have the performance package and it's a manual transmission.
The blue and 3 pink wires go to additional connectors that I don't know what they were for. All I can figure out is that these mystery connectors have grey wires that go back to the White BCM multi-plug for "instrument panel lamp supply voltage". I assume I can cut these out.
The green wire runs over to pin 2 on the obdii connector. I presume I'll have instructions for that wire later.
Anyone care to confirm my thoughts here?