I apologize if this is in the wrong thread - I could not find one specific to steering.
Has anyone every pulled apart the U joints on the Cobalt steering shaft? I’d like to powder coat it, but don’t want to heat those cross bearings up when I go to cure it
Ive never seen this type of cross bearing retaining methodology (without retaining clips). Any thoughts?
Has anyone every pulled apart the U joints on the Cobalt steering shaft? I’d like to powder coat it, but don’t want to heat those cross bearings up when I go to cure it
Ive never seen this type of cross bearing retaining methodology (without retaining clips). Any thoughts?
Attachments
-
405.7 KB Views: 139
-
318.3 KB Views: 137