Need to find out what to do with the rear lighting situation...
I have three brown wires coming from the junction in the middle of the loom, along with a yellow and a green coming from the red BCM J3 A9 & A12, respectively. the video mentions the tail lights however, I should also include a wire for the license plate lights too, havnt looked to see which spot on the plug to use yet.
There is also a green wire that is coming from the body-to-engine connector that I am not entirely sure what to do with, I havn't taken the time to track that down. I still have an EvapPump wire (pink/white) sitting in the middle of the table [ coming from the fusebox ] that I have no clue what to do with, again have not taken time to tracked down.
holding out hope that the wiring harness video series continues and the DF guys in Texas are doing ok.
also I should note i am finding differences in comparison to other cobalt wiring and many more confirmations that I am on the right track.
I'm still working out all the connection mapping for the draw.io harness map.
I feel obsessed to get this part absolutely right