Recent content by aaronc7

I think they are holding off posting this until the driving stage is finalized. I know they are working on getting wheel speed sensors working, which could drive the need to change hubs vs what they used on the prototypes. I asked them the same question a while ago :).

I stumbled across this today and this seemed like the best place to share. Guys at DF have been making some period updates/posts about the V2-- on their blog site. Check out the last 2 pages or so. https://dfkitcar.com/blog

Those are the FX1 Pro seats, size Large?

^^^ this is what I did years ago. You can buy a 1 day subscription or something like that. I went in and downloaded every manual related to my car and it's been a great resource to have.

OK think it's pretty close to where i want it. Probably do something a less busy for the boost eventually. Inspired by my S3 digital dash.

250. I already have one out of a 1.8 a3, which has similar ratios to a GTI. I was just really looking to scoop up one of those, especially if I were going to go thru with installing a wavetrac etc. Oh well.

The gear ratios are much tighter spaced-- yeah you'd have to remove the AWD component

Haven't had a chance to test in an actual car, but reads everything off bench ECU correctly. Now I just need a Goblin lol.

Side note I really wanted to find a TTS or R or S3 trans to put in my goblin, but was not successful. They are crazy expensive usually.

Very nice, I've had a 17 S3 for 7 years now as my daily. I'm pretty sure the magride was about dead when I picked it up with 30,xxx miles. When I finally replaced them around 70k miles, one of the shocks was standing upright on the garage floor, it basically exploded and the top half **** near...

Nah, NW Florida. Not many hill climbs here either .

Would love to read any writeup or insights for the DSG diff install. I've had a wavetrac sitting in a box for some time now waiting to go in, after not being able to find a shop that was comfortable with it locally. Are you sticking with GTI gear ratios or going to the tighter R or TTS ratios?

Yeah, guy has ported head and aftermarket intake manifold as well.

Low psi, but here's some data/logs https://datazap.me/u/steveppd/logs/cmmwq87cn000bl406ws0uzv3b?channels=19x8&sizes=50x50&sc=8-19

I looked into those, it looks like PiDash simply runs the Tuner Studio gauge software? I looked into that, but it seemed like that software only supported a few specific aftermarket ECUs and their CANBUS format. Great if you're running one of those ECUs, otherwise you gotta use an Arduino or...