Recent content by Grayson

The partial engagement is a similar feeling to an automatic car letting off the brake and rolling forward. I think im going to buy your same clutch setup and try it. Are you using a bellhousing spacer on your goblin?

I have been using the bellhousing spacer. Here are my current options: 1. Remove bellhousing spacer and see if it fixes the issue 2. switch to a f35 throwout bearing 3. replace clutch and pressure plate It seems like one or all of these might fix my issue but would rather not have to do all of...

I didn't touch the clutch when I switched the transmission from an f35 to an f23. Its possible the previous owner would have installed it backwards but I feel like that would cause issues when it was the f35 transmission as well. I could swap my clutch. Are there any recommendations on the best...

This is correct, I've tried replacing the master cylinder as I thought it was a bleed issue but its consistent unlike air in the line. It seems mechanical. The clutch isn't slipping. My first thought was that I was using a f23 throwout bearing but from what I have seen on the forum it should...

Hi everyone, I have been having issues with my clutch engagement and have reached the point where I am totally perplexed. I have an lsj with an f23 swap and a f23 throwout bearing. The issue Im having is when the clutch pedal is fully depressed the car rolls forward, when its halfway out it...

Gotcha, Ill check that out. I am hoping I can make a sheets with all the parts I used so I can put in the bottom of my videos mainly. Heres what Ive got so far: https://docs.google.com/spreadsheets/d/147eagRUGfpmyNld3ficrUAQYe3KpBN6JiA1po4fbYXc/edit?usp=sharing If anyone wants me to add...

So we got the car Driving! Made a couple of videos since then showing off the Goblin. Here are those videos for anyone interested. Also, I am going to work on a list of Goblin compatible parts and parts that I used on my build as I've been getting a lot of questions about it. It will probably be...

So I realize I meant to look into the South Dakota route not carolina. Apparently its similar to Montana but cheaper and no LLC. Im trying the texas route first but if I get kicked back I might try Montana or South Dakota. Sorry y'all! Wrong thread!

Hey Y'all, just finished my Goblin and Im at the registration phase and wanted some input. It seems that South Carolina is the easiest to get a title and registration. I am in Texas and there are more hoops to jump through than the circus so I was thinking getting it titled in south carolina...

I did end up keeping the plate and it seems that others have too. If the fluid fixes it then Ill leave it at that but if it doesn't Ill try removing the plate.

Awesome! Yea I do a lot of social media work for them here in Dallas. I have a garage at the carrollton location

I'm helping host and event called Garages and Gearheads this Saturday at Garages of America in Carrollton. It's 9am-11am at 2323 Tarpley RD Carrollton TX! I will have my Goblin there and it seems like someone is also bringing out their turbo LNF Goblin. Its a free and open event for anyone who...

Hey Everyone, I figured I would make a thread for all the Dallas people to post events! I know there is a couple of posts from a while ago but here is a thread to post all DFW car events.

They don't have MT-90 in any stores near me but they do have this. https://www.autozone.com/motor-oil-and-transmission-fluid/manual-transmission-fluid/p/pennzoil-synchromesh-transmission-fluid-1-quart/265000_0_0?searchText=Redline+MT-90+MTF Seems like this works because its syncromesh but not...

What fluid did you use when you re filled your trans? Im about to go buy fluid.