V1 Tweaking Wiring Harness Winter Project

[ncgoblin]

Hey Guys,

Its been 3 years since I originally built the goblin and I have never been 100% satisified with the wiring since I was overly cautious back with the original videos and so I have a decent amount of bulk in my wiring I would like to free up.

Now there are a few ways I can go about this.

1. Cut unused wires after tracing them back and confirming with alldatdiy diagram.
2. Pull the entire harness lay it out on plywood, go through the new videos for exact lengths. If I go this route is there a source for what exact Pinouts are required for each BCM/PCM connectors? This would make life easier.
3. In addition I can also cleanup my stereo, AFR, and Oil Sensor wiring.

I am leaning towards option #2.

 

[Cnixon160]

The second option will ultimately prove easier unless there's very few wires to remove, being able to see the entire wire will make removal and tracing significantly simpler