-
We've upgraded and reskinned the forum. Notice something off? Email us at [email protected] and we'll fix it.
V1 .
Robinjo
Goblin Guru
- Robinjo Goblin Guru
It will, but if your planning to also run an AFR gauge I would recommend having the dual mount 3D printed somewhere. I think Rauq had one that held the AFR, Boost and light sensor. Also, run that wire from your A/C pressure sensor to the front of the car before you button the center console up and put in the seats.
Robinjo
Goblin Guru
- Robinjo Goblin Guru
The do not do that, I do not believe. It would come off your engine harness, unless you sent them that as well?
Here is how to run that line. This is assuming you want to run HP Tuners at some point. If you do not plan to use HP Tuner and make Mo Powa Baby! then disregard this below. I thought I wasn't, then changed my mind less than 2 month later and wish I had run that line....
dfkitcar.com
Here is how to run that line. This is assuming you want to run HP Tuners at some point. If you do not plan to use HP Tuner and make Mo Powa Baby! then disregard this below. I thought I wasn't, then changed my mind less than 2 month later and wish I had run that line....
Wiring Wideband O2 Sensors
This has been a popular topic recently, so I'll attempt to write something up that can be referenced rather than adding information piecemeal in response to various questions. What is an O2 (oxygen) sensor? Spark ignition engines must inject a precise amount of fuel based on how much air enters...
Last edited:
Similar threads
