V1 Build Guide Part 18 - Main Harness & Dash Accessories

[Adam]

Build Guide Part 18 - Main Harness & Dash Accessories
In Part 18 we install the main harness, gauges, ignition switch, battery ground and positive cable.

 

[Ross]

@10:20, we solder on a copper lug end to the positive wire. Is that lug suppose to be part in the kit? I was able to save the original Cobalt lug, so I won't have to make a trip to the store.

 

[Briann1177]

I'm pretty sure it's included. But then again I thought the front coilover wrenches were included too. I'm 99.9% sure you're supposed to get a lug in the kit.

 

[BaltimoreHokie]

@10:20, we solder on a copper lug end to the positive wire. Is that lug suppose to be part in the kit? I was able to save the original Cobalt lug, so I won't have to make a trip to the store.

I think it was...

 

[askiles]

I think it was...

The lug is part of the kit.

 

[chief404]

I'm confused at the grounds in the middle @ 8:30. The only grounds I have are the two lugs at each end of the car and the four extended wires @

. Are the four extension wires soldered to a lug and connected to the middle ground point?

edit: after looking at this image, I'm going to assume I was right about those extensions. I wish video #11 had added soldering the lug.

https://dfkitcar.com/forum/index.php?attachments/main-harness-with-labels-medium-big-labels-jpg.1712/

I also did not receive a lug to cut the positive wire in my kit - it is not listed under the itemized build sheet