Search results

Yes confirmed there is a Tee.

Thank you Lonny. This is what I needed!

Alright guys, you have been so helpful and I need your help one more time on the wiring. For the turn signals I am lost on how they get tied in. I have all the turn signal switch connectors sorted but getting tripped up on the wiring to run to the mirrors. The video shows adding 2 orange...

Thank you everyone for the replies on the wiring. That is super helpful.

I know, I have you to blame. :) I think I read one of your posts somewhere that I will need a spacer in the rear?

I'm getting really close to having my wiring harness sorted out. I just need to figure out a couple last things such as how the turn signal wiring gets integrated. I still have this connector which I am pretty sure can be removed but I would like confirmation. This is up near the ignition. I...

Does the data wire need to be extended and tied into the other data wires in the dash area?

Do you have the brake sensor and clutch sensors wires reversed?

Both bottom holes, is what I was told.

His is extended, not sure about yours JSATX. Also the cobalt seats are probably heavier. Track Frame Halo. Also full tank of gas is about 45lbs.

Yeah I think you should buy it.

How do you deal with tail lights?

Well I can't procrastinate any longer, time to finish my wiring harness, its all that stands between me and a hopeful first start. I had gotten about half way done when the new videos started dropping. I discovered one mistake I made due to the new videos. I had cut out the wire that is to be...

I dont have any direct experience but did read where Georgia was starting to go after exotic car owners who were registering in Montana to avoid taxes.

It depends on Covid-19 for me. No way to avoid crowds out there so I will have to see when things get closer.

Is running the stock bushing a problem for SS/TC? Mine are in decent shape and I wasnt planning to replace.

That explains it.

Thank you, that is helpful. I had not found that thread before. The other thing I notice is I have two holes for the steering arm where the videos only show a single set of holes. Did you mount through the top holes or bottom? In my picture I have it top on the left side and bottom on the right...

Working on the front suspension. I hadn't seen it mentioned how tight the steering rack and passenger side suspension are. I had already torqued the steering rack and had to remove it so I could get the bolt for the suspension in place. I think I have these lined up correctly. I was surprised...

Thanks guys. The PB blaster, torch, and big freaking hammer did the trick.