V1 Heat exchanger wire not found

[Oldchevyguy]

If you are using the NACA duct kit the fan is not used. At least that is my understanding

I really do appreciate your responses, but they are a little off the mark from what I am asking.
I am not using NACA ducts. I plan on using the heat exchanger with the fan as supplied.

I need to run a power wire to the fan. It dosent matter if I use a doner wire, or another. Where do I hook it up? This is my question. Thank you.

 

[DCMoney]

I really do appreciate your responses, but they are a little off the mark from what I am asking.
I am not using NACA ducts. I plan on using the heat exchanger with the fan as supplied.

I need to run a power wire to the fan. It dosent matter if I use a doner wire, or another. Where do I hook it up? This is my question. Thank you.

Heat exchanger fan wiring

Before thinning you body harness locate pin D7 on the big red BCM plug. There should be two pink wires coming from it. One of the wires goes to the passenger seat plug. The other goes to the inflatable restraint module plug. Cut these two wires about an inch from the big red plug and solder on...

dfkitcar.com

 

[Acewest]

Yeah. Old videos wont be all that helpful once your that far along. Use this for reference on the plugs.

Cobalt Fuseblock and More.pdf

drive.google.com

Where can I get the same diagrams for the bcm plugs

 

[Ross]

Where can I get the same diagrams for the bcm plus ?

log on, and look at AllDataDIY

Anyone know where i can get Cobalt wiring diagrams?

I'm trying to thin the wiring harness. The movies move really fast and dont contain all the information needed, particularly if your car is not equipped like the base model depicted. I'm a retired auto mechanic and shop owner. I use to pay a lot of money for Alldata and Mitchell on demand...

dfkitcar.com

 

[Acewest]

Alldata don’t seem to have my model correct

 

[Ross]

Alldata don’t seem to have my model correct

I thought we had the same donor. 2006 SS 2.0L SC?

 

[Acewest]

Yeah but idk. Finding info on All-data is not really helping. I found what I needed on here. After I bought alldata

 

[Karter2026]

For BCM plugs. it is pretty simple with alldata.
Go to Diagrams>Connector views>Body control Module> then choose C1, C2,C3 or C4 All pin locations and wire colors are listed there