SliderR1
Well-Known Member
For those of you that have completed your build - I'm looking for a picture of the rear of the car - from directly behind it.
Reason I'm asking is that I'm working on some custom tail lights. I picked up a pair from a 94 DeVille that I'd like to place horizontally. Also planning an LED retrofit for these. I've got someone 3D scanning them now so I can draft and print some new housings, then I'll fab up some brackets for the Goblin application. I'm trying to figure out where they might work best.
It appears with the supplied engine cover that the top horizontal brace bar is covered - from an old picture of P1 I found. I thought about adding a bolt in horizontal bar just below the existing tail lights brackets - it appears there are some tabs there for the wing/spoiler...
I guess the main question is has anything changed on the back of car since this picture of P1 was taken?
tail lights
Reason I'm asking is that I'm working on some custom tail lights. I picked up a pair from a 94 DeVille that I'd like to place horizontally. Also planning an LED retrofit for these. I've got someone 3D scanning them now so I can draft and print some new housings, then I'll fab up some brackets for the Goblin application. I'm trying to figure out where they might work best.
It appears with the supplied engine cover that the top horizontal brace bar is covered - from an old picture of P1 I found. I thought about adding a bolt in horizontal bar just below the existing tail lights brackets - it appears there are some tabs there for the wing/spoiler...
I guess the main question is has anything changed on the back of car since this picture of P1 was taken?
tail lights
