Search results

A room opened up and I reserved it just now. Looks like I don't have to sleep in the trailer after all...

I pictured a 3d printed 2 piece profile that basically clamps to the tube and rotates to adjust aoa or we just throw a huge wing on like a sprint car...

is it ridiculous to consider creating a wing profile around the roll hoop tube? Seems like it might solve a few problems with goblin geometry it woold put the wing forward of the rear wheel, and in clean”er” air

And the z54 is $50 short of the z57…. lol where does one draw the line? I don’t need more power yet. I need traction for the power I make right now.

Yep. Maxed out the stock turbo. Probably pushing it a bit too hard

the lug studs were touching on both sides There is no room for a lug nut for some reason in my head I picture a plywood wheel burnout burning smoke in reality it would probably just rapidly disassemble the plywood.

I did a thing today, Had the boost gauge sitting at 24PSI the whole pull, It started to get hot I wish I would have been better prepared and brought my laptop to do a data log. I'm really curious how hot the iat2 was getting with that long of a pull. It is significantly less power than I was...

If I’m still able to make it I will be alone I was able to get the goblin in the trailer last night. It was a tight squeeze but if it fits it ships

We had a pretty bad thunderstorm early this morning so setting up generators has delayed my day a bit but I will put the pizza cutters on and try to fit it in the trailer today sometime If it won’t fit I’ll have to either order the tow bar kit and hope it gets here in time to install it or rent...

lol I ran mine mor to the interior behind the alternator. dumn mistake i guess I was going to 3D print a standoff to tie wrap or hose clamp to the fuel tank strap or a bracket off the alternator bolt itself...

I was intending on staying in the trailer It’s insulated and has ac and heat. I’m going tomorrow or Saturday to grab a couple donuts to see if I can make it fit unless someone here tells me the width of the front lug studs is over 64.5” I’ll measure after swapping the wheels. @Lonny any...

Very cramped and a lot of potential big problems from anything being a little bit not perfect… I will be making some sort of bracket to secure the hose and keep it off of the alternator and fuel tank

No vacancy Friday night unless I get this trailer situation sorted out.

On a more serious note honest thoughts on using the donor heater core as a second heat exchanger for the intercooler?

I had planned on welding a couple tabs to the tube before pulling hoses but didn't get it done, 3M VHB tape was considered but ... I want to be able to non destructively remove side panels for various reasons... A little single sided foam tape and rivnuts where I can should be fine.

******Goblinfest ****** I got permission to attend! Surprised me a bit but she didn't have an issue with it at all. Anybody with experience have a recomendation on hotel in the area? I had planned on using a friends enclosed trailer to tow down, turns out front wheels are an inch and...

Coolant leak located! I haven't had a chance to fix it yet but it is definitely coming from the right side splice between the frame rail and cylinder head near the alternator. I want to get it out today and send a data log to my tuner, run the e85 out and start a 93 tune, Floor rubber mats to...

Any recommendations for accommodations? I'm trying to figure out the logistics of getting down there and back, My initial plan to borrow a friends enclosed trailer might not work so I'm considering driving the goblin the 525 miles down and back.

Still Hunting for my coolant leak. I am running out of ideas for where it could be It only leaks sometimes and never when parked.

Matt is doing my tunes and I have been very happy with results this thing screams