• We've upgraded and reskinned the forum. Notice something off? Email us at [email protected] and we'll fix it.

Corbeau seat mounts

AZmoto

Well-Known Member
AZmoto
Is there physically room to mount the Corbeau seats lower than where the DF mounts place them? If so, about how much lower could they go?
 
RouteAbel
I think you could potentially lower it about an inch. You could maybe get 2 inches if you were to cut off the mount for the submarine belt of the 5 point harness.
 
Rttoys
Check out Planted technology cobalt seat mounts SB225DR and PA

Not sure if this helps, but they sit right on the rails of the goblin. direct fit to a cobalt, so direct fit on the goblin.
 

Attachments

  • 7F9A22AC-F006-4E0A-A75B-52FE14FCC320.jpeg
    7F9A22AC-F006-4E0A-A75B-52FE14FCC320.jpeg
    256.6 KB · Views: 466
Mayor West
Check out Planted technology cobalt seat mounts SB225DR and PA

Not sure if this helps, but they sit right on the rails of the goblin. direct fit to a cobalt, so direct fit on the goblin.

I almost got these for my Braum seats, but the person I was reading up on who bought braums before me said he got these and they didn't work and need a LOT of welding ot make work.

I'm sorta bummed that I didn't go this route because I'd much rather this way of installation rather than my stopsign brackets that I did.

Also those seat mounts are not cheap.
 
Back
Top