V1 Manifold / Muffler Hardware

[Jareth]

So my donor did not have any exhaust on it when I got it, I checked what hardware I have just to determine what the thread size The bolts are that I need to buy but nothing I hav seem to screw Intro the manifold, does anyone know what bolts I need to buy?

.

 

[Jareth]

Dawned on me I could just use my tap set and figured out that it is a M10 X 1.5 Thread.

.

 

[k.rollin]

Here's a one stop option if they're in stock; I used them after breaking several studs while breaking the engine down for paint (then I didn't actually paint the engine lol)

https://zzperformance.com/products/exhaust-manifold-studs-and-nuts

 

[Jareth]

Thanks, but its just the three that mounts the muffler that I was looking for.

would these be appropriate?

https://www.amazon.com/ARP-772-1003-Bolt-1-50-Pack/dp/B00I5AR0MI/ref=sr_1_9?crid=3HKI52P70PN6O&keywords=m10+x+1.5+bolt&qid=1637540013&s=automotive&sprefix=M10+X+1.5+Bolts,automotive,182&sr=1-9


.

 

[Scott #321]

Pricey option but should be fine. Make sure to use antiseize.

 

[Jareth]

Yes, no need to throw money away, I‘ll get something from AceHardware

.