GoblinGuyZ's latest activity
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.Yeah that happened to me first try as well but I realised right after so I removed it. I cleaned it out fully as well -
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.Thanks. Knowing this is how it’s supposed to install is helpful. I first assumed that but could not get it in thay way either lol. So...
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.thanks but I’m fairly sure I’m doing everything right and it’s not like it’s rocket science. I’ve built entire cars and engines and...
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.Sooo please tell me I’m doing something wrong. I have spent the last hour and a half literally trying to get the clip back into the...
-
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.Think I found a pic. It’s the one below
-
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.yeah that I know I just haven’t put back the wires yet they are all in a heap so gotta figure that one out and I’m guessing it won’t...
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.Hi all so trying to get this thing fully put back up to go for a drive and see what’s what but can’t remember the exact location for...
-
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.Sigh I hope not either. I have another engine there to build so I will probably be back at it at some point. I have to reconnect...
-
GoblinGuyZ reacted to ah.b.normal's post in the thread New Gearbox / Clutch Upgrade Procedure with
Like.
You can save a little time and liquids by supporting the engine from the top with either a bar and chain across the frame(but there is... -
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.To bolt it all back I’m going to lift the engine with the hoist, slide the subframe under onto 4 jacks stands then bolt the engine back...
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.This was the carnage that was last night lol
-
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.Thanks. Started last night and did more than was necessary but more or less figured out what you just said would be the best way next...
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.Hey man thanks but unfortunately I got a lightweight one with my clutch. Wish I had known before.
-
GoblinGuyZ replied to the thread New Gearbox / Clutch Upgrade Procedure.Thanks that’s helpful. Will see how it goes
-
Replace the main seal on the crankshaft? It is cheap, and hard to get to. I replaced the clutch hydraulic slave, and the 3 short bolts...
