Latest activity
-
D&dgoblin69 replied to the thread Can't get CV Axle back in.What I do to get new axle in is first make sure the shaft is aligned by putting some pressure on shaft and turn it if the other axle... -
Mahkoi replied to the thread Just great.The one that broke look a lot like my snap on rethread/ chaser kit. Not sure if they are the same or not but it's a tool I use a lot and... -
GGtstorey replied to the thread Just great.Probably need to stop buying certain types of tools off eBay. The ones pictured looks like real taps. The one that broke doesn’t.
-
Desert Sasqwatch replied to the thread Just great.Another alternative: Taps have 3 or more gaps around their circumference. It may be possible to tap/pry/finesse a tool into these to... -
Jareth replied to the thread Just great.This is the kit I was using click ABN Metric and SAE Standard Tap and Die I hate at my age making rookie mistakes, should have used... -
I recently broke an ez-out while trying to remove a broken brake bleeder screw on a 4 wheeler caliper. No drill bit i had would touch it...
-
I had an issue where if you cycled the lights it would allow the vehicle to start but would not start without cycling the lights. I kind...
-
Desert Sasqwatch replied to the thread TO HOT?.That looks like a lonely snow covered potential Goblin sitting in the grass! :D
-
Mahkoi replied to the thread Just great.I recently broke an ez-out while trying to remove a broken brake bleeder screw on a 4 wheeler caliper. No drill bit i had would touch it...
-
GGtstorey replied to the thread Just great.True. If they aren't hardened steel, probably isn't necessary to use left handed bit. Although it might easily unscrew the broken...
-
Joebob replied to the thread Just great.the way they are coarsely machined and heavily stamped, they don't look like hard material. They look more like thread gages than taps... -
GGtstorey replied to the thread Just great.You probably aren't going to drill into a tap. Typically, the tap is going to be much harder than a drill bit and as you have learned...
-
Jareth replied to the thread Just great.Maybe this one, or is there something better...
-
Was trying to use I guess a tap to clean out the threads of the headlight mounting thread and this snapped off. Size 3/8 X 16 So I...
-
Robinjo replied to the thread Electrical start issue.I had an issue where if you cycled the lights it would allow the vehicle to start but would not start without cycling the lights. I kind...
