Ross's latest activity
-
Ross replied to the thread 2006 SS/SC crank but won't start.Disconnect the MAF sensor, and see if it stays running. That forces the engine to stay in VE mode, as it knows there is no MAF sensor... -
Ross replied to the thread TravMac's Extended Track Goblin (#253) - 2007 SS/SC Doner.Can you space out the AC compressor from the block, with some longer bolts, and extra washers, and use up that extra length in the 6 rib...
-
Ross replied to the thread Discount on dual spray injectors..
-
-
I’d say I’m pretty lucky
-
Ross replied to the thread Sneak Peek - Goblin V2.Maybe a trip to GoblinFest 2025 would give you some comfort in the V2 product. I am hoping to get to see the progress.
-
Ross replied to the thread Ross's extended city, easy entry Goblin- 06 SS/SC, NW Arkansas.Today I found 2 leaks in my gas tank system, by using my smoke machine. One was a hose clamp that needed tightening, and the other was...
-
-
Ross reacted to pisco's post in the thread Pisco's extended city goblin #220 (2009 SS/TC donor) with
Like.
Turns out everything was wired correctly, everything is fine except my right was left and left was right.... I built the harness 4.5... -
Ross replied to the thread Engine wire harness question, injector plug..I found it here. Yes it supplies power to the BCM.
-
-
Oh. I forgot. The track wasn’t setup for it this time, but they can use the banked part of the track for autocross. :cool:
-
Ross replied to the thread "Locked"-Instrument Panel-Gauges Die.My vote is a Canbus issue. Maybe run some tests on it to see if it has 60 ohms.
-
Good looking bunch here. :cool:
-
Ross reacted to pisco's post in the thread Pisco's extended city goblin #220 (2009 SS/TC donor) with Like.
I've been crickets here for a while. successful test drive #1 last Saturday, a quick alignment adjustment then #2! took it to a buddy's...
-
Ross replied to the thread Engine mounts.Lift the engine when the bolts are loose. Either jack it up from the floor, or lift it from above. Made a big difference on mine.
-
Ross replied to the thread Back at it - maf sensor / among few others.Okay. So that is the way your meter reports infinity ohms. Did you have the wiring harness attached to the BCM, ECU, Power Steering...
-
Ross replied to the thread Back at it - maf sensor / among few others.Unplugging the power steering shouldn't cause the Canbus wires (pin 6 and 14) to short out (1 ohms). Does your meter read 1 when the...
