SwerveMonkey's latest activity
-
SSwerveMonkey replied to the thread Re-use of Aftermarket Donor Springs.I'll hold on to them then and see how things go... in the meantime I'll reinstall them on the painted struts
-
SSwerveMonkey reacted to Desert Sasqwatch's post in the thread Re-use of Aftermarket Donor Springs with
Like.
I believe those Eibach springs are 2-3 inch drops, which are much lower than cutting a coil from the stock springs. You can probably... -
SI've been trying to find examples of what to do with aftermarket donor parts, specifically springs.... not sure if I am looking in the...
-
SSwerveMonkey replied to the thread SwerveMonkey's Street Goblin - 08 Donor.Alright! got some traction on the project again during what was a rare glimpse of Long Island warm spring weather... skies 've been sort...
-
SSwerveMonkey reacted to Desert Sasqwatch's post in the thread SwerveMonkey's Street Goblin - 08 Donor with Haha.
I believe most everyone did the same thing, pulled the axles and were rewarded with a puddle of trans fluid on the floor. Like I stated...
-
SSwerveMonkey replied to the thread SwerveMonkey's Street Goblin - 08 Donor.Still prepping the pedals has proven to be a bad time, lol. I broke the bolt holding the clutch sensor, there was thread lock was on...
-
SSwerveMonkey replied to the thread SwerveMonkey's Street Goblin - 08 Donor.been a hot minute for sure... but given the situation this was not a top priority to press forward until settling into the new norm...
-
SOrder now and just wait for it to be done. It's a safe bet it'll be a few months.
-
SSwerveMonkey reacted to bradr's post in the thread Goblin Electrical Connector Info & Part Numbers with Like.
I have been continually updating this spreadsheet with new information and corrections. You will find a ton of tabs across the bottom -...
-
SSwerveMonkey reacted to Mayor West's post in the thread Can a lowly teenager build a DF Goblin? with Like.
You're not building it from scratch, you're assembling it as a pre-made kit. As long as you have the space and time, the forum can fill...
-
SSwerveMonkey replied to the thread Another Harness Mistake.@Lonny, TEN-FOUR!! I've been preoccupied anyway having to convert and cover my wiring table as a quarantine clean zone... long story...
-
SI think Adam had the script almost ready for me to record. The other videos are close. If you start to question anything it may not be...
-
SYou've gone and done it, SwerveMonkey. You've unintentionally convinced me to proceed with my harness using the old videos. (You, and...
-
SSwerveMonkey replied to the thread Another Harness Mistake.after rewatching the original wiring section i noticed that the ignition assembly has a spot that the keylock would normally go in...
-
