Goblin Front Splitter Group buy
- Thread starter talon2006
- Start date
SmsDetroit
Goblin Guru
Can people post how they mount theirs once they get them.
Mahkoi
Well-Known Member
I planned on sharing some pics. If my plan works I may have left over hardware I can pass your way. I'll let you know how it goes.
SmsDetroit
Goblin Guru
I was thinking of adding support cables.
SmsDetroit
Goblin Guru
Am I remembering correctly that we need to reverse the fan on the inner cooler and add a hood scoop on the bottom of the splitter?
Rttoys
Goblin Guru
I switched mine from pull to push when I had the cutout and scoop.
KSLunsfo
Well-Known Member
Did you flip the blades around on the fan or just reverse the polarity?
Rttoys
Goblin Guru
I bought another fan. used the spal first, then the perma-cool. both worked fine, the perms-cool is reversible, so if you change things in the future, it’ll still work.
Spal 7.5 pusher fan ic rad SPU-IX-30100393
Perma-cool 8” push or pull 19128. Stronger than spal
Sluggonaut
Goblin Guru
This is the one I ordered when I needed to replace one. It's an exact match to what I received in DF's kit.
Markm
Well-Known Member
Thank you sir
Talons Garage on Instagram: "Back home from united by bronco and putting the laser to work! This is the front splitter for a DF Goblin being cut!"
14 likes, 0 comments - talonsgarageMarch 6, 2024 on : "Back home from united by bronco and putting the laser to work! This is the front splitter for a DF Goblin being cut!"
www.instagram.com
Started production on the splitters! Looking forward to getting them out the door!
SmsDetroit
Goblin Guru
Here’s to hoping they get here soon
MattyP
Member
Think I missed the signups, I DMed you!Talons Garage on Instagram: "Back home from united by bronco and putting the laser to work! This is the front splitter for a DF Goblin being cut!"
14 likes, 0 comments - talonsgarageMarch 6, 2024 on : "Back home from united by bronco and putting the laser to work! This is the front splitter for a DF Goblin being cut!"
Started production on the splitters! Looking forward to getting them out the door!
Pm’d you back. If there is a few who missed the link we can get you on today/tomorrow if you email us.
I will be traveling tomorrow to get a new piece of equipment, but if you email [email protected] my wife can get you taken care of.
I am hoping to bend them Friday. Hopefully also get them packed and shipped early next week. There are a few orders that came in later, and will be cut starting next week. I decided to move up production on those who ordered over the weekend instead of waiting till next week to cut all of them.