.
- Thread starter LLBenJ
- Start date
Sluggonaut
Goblin Guru
I had one 3D printed only to find out my mounts were slightly different.
While building, I would tilt my head when I looked at my boost gauge to counteract any OCD only to realize after driving that if you are in boost, you really can't look at the gauges very long for it to matter.
While building, I would tilt my head when I looked at my boost gauge to counteract any OCD only to realize after driving that if you are in boost, you really can't look at the gauges very long for it to matter.
Robinjo
Goblin Guru
This is very true. I can glance at my gauge but never watch it. Of course, I only have a couple months of driving experience but I can't see it getting any better than a quick glance.
I didn't try my boost gauge in the DF holder, even though I also powder coated it. I knew I was going to run a AFR gauge so I just did it with the dual holder.
Last edited: