Schematic of each sensor on the SS/SC

LLBenJ

LLBenJ

Active Member
I'm getting ready to complete a cleanup of the donor engine and I'd like to remove the entire harness prior to doing so. Many of the sensors/connections are labeled but several are not. Is there a good diagram/schematic of the SC sensor location/configuration so I can positively identify, and label, each of them prior to the harness removal? Thank you in advance.

Ben
 
Jareth

Jareth

Goblin Guru
What I did was just use two labels one on engine and one on connector, 1 to 1, 2 to 2, 3 to 3, …etc


.
 
R

r3drckt

Goblin Guru
When you log in, on the right side look for “diagrams” and then “components” and you will see the list of component names and where they are located.

You can use this information along side the “Connectors,” “Connector Views,” and “Harness” diagrams to figure out what is what.

I will add that the harness diagram for the engine doesn’t show the LSJ for whatever reason, but it may hall none the less as the ecotecs generally placed things in similar locations.
 
Sluggonaut

Sluggonaut

Goblin Guru
Jareth said:
What I did was just use two labels one on engine and one on connector, 1 to 1, 2 to 2, 3 to 3, …etc
Click to expand...
Same here. If I knew what it was, I labeled it as such. If I didn't know, I either guessed or numbered it. As long as you have the same label on both sides you can plug it back in where it belongs.
 
You must log in or register to reply here.
Top