Correct nuts for hub studs?

[Leo Zugner]

I ordered the 5x114.3 hubs but I don't think I got the nuts for the studs that mount to the upright (see attached) in my order and I didn't see them on any of my packing lists. Can anyone tell me what those nuts are supposed to be? I tried some m10x1.5 that seemed super close but still had some slop and stripped when i tried to tighten them.

Thanks

 

[comegetjoe]

Donor supplied.
I have 10 x 1.5 ordered in my Amazon past orderes as thats what I used and I had zero issue tightening them down.

 

[Leo Zugner]

Donor supplied from where on the cobalt? You ended up buying new ones?

 

[comegetjoe]

Yes. Supplied from the cobalt donor from the factory locations.
Yes. I did buy new ones off of Amazon.

 

[Gtstorey]

Typically, you would use the nuts that were holding the hub on the donor.

Just like everything else there are a lot of low quality/counterfeit fasteners out there so maybe you got bad ones. I has some that I bought by the pound at Rural King that fit loose and stripped before they tightened on my hubs.

 

[Leo Zugner]

Typically, you would use the nuts that were holding the hub on the donor.

Just like everything else there are a lot of low quality/counterfeit fasteners out there so maybe you got bad ones. I has some that I bought by the pound at Rural King that fit loose and stripped before they tightened on my hubs.

Ah! It didn’t occur to us to check the rear hubs. That step in the videos skips over what those nuts are or what size they are. Thanks for your help.

 

[comegetjoe]

Ah! It didn’t occur to us to check the rear hubs. That step in the videos skips over what those nuts are or what size they are. Thanks for your help.

Pretty sure I asked the same question at some point. Possibly for the same reason.