V1 Sanity check about missing connectors on body harness

[devianteng]

2007 SS/SC.

Just finished up with video 8, where we thin the body harness. Relatively quick and smooth but 2 connectors mentioned in the video, I don’t seem to have.
Traction Control Connector (step 12; 3:30)
Steering Angle Connector (step 22; 7:05)

I assumed that not all Cobalts had these connectors, therefore nothing to remove for me.

Further, I had left the heated seat switch connectors, so I thinned those from the harness. Hopefully that was also expected, even though it wasn’t mentioned in the videos.

Made some good progress this weekend, but wanted to make sure I didn’t mess up with the above connectors before I continue.
Thanks!!

 

[r3drckt]

You’re correct. ‘06 SS/SC for me and I didn’t have those connectors either.

 

[devianteng]

You’re correct. ‘06 SS/SC for me and I didn’t have those connectors either.

Thanks! Did you have heated seats in your donor?

 

[r3drckt]

No sir

 

[Sluggonaut]

Thanks! Did you have heated seats in your donor?

Same here and I also thinned the seat heater wiring after the fact as they were still around after everything else was removed.

 

[devianteng]

Same here and I also thinned the seat heater wiring after the fact as they were still around after everything else was removed.

Great, sounds like I did was I was supposed to. Thanks for letting me know!

 

[Sluggonaut]

Great, sounds like I did was I was supposed to. Thanks for letting me know!

Maybe, I have not made it through first start yet. I'll let you know once I get there unless you beat me to it.

I did my harness back in December when I thought I was picking it up myself. I ended up having it shipped so I had a bit of a gap between completing my harness and starting my build.

 

[devianteng]

Maybe, I have not made it through first start yet. I'll let you know once I get there unless you beat me to it.

I'm still a ways out. I'm trying to finish the harness, then I have a few frame mods planned, then off to powder. While at powder, I still have to prep/clean/paint donor parts. I'll be surprised if I have my first start before June.

 

[Sluggonaut]

I'm still a ways out. I'm trying to finish the harness, then I have a few frame mods planned, then off to powder. While at powder, I still have to prep/clean/paint donor parts. I'll be surprised if I have my first start before June.

I was lucky enough to catch some of the 60 degree days we had a couple of weeks ago to get my donor parts painting done. We really haven't had many painting days since.

I realized I didn't paint the upgraded rod ends so when I dropped my recently received Option B bracket off at the powder coater I included those. I'm back to waiting on powder again, this time to finish assembling my uprights I received last week.