Help with screw

[Metal Mech]

Wasn’t sure where to put this.
The screw that holds on my position sensor for my brake pedal snapped. I’m pretty sure I can remove the broke section but I need a replacement. Anyone know the specs and where I can get it?

 

[Traé]

If it can be removed take it to the hardware store and match it up with the nut and bolt gauges.

 

[Rttoys]

I can look it up tomorrow, but I doubt it’s available.

 

[Metal Mech]

I can look it up tomorrow, but I doubt it’s available.

Thank you appreciate it. If it’s not available I may just drill out the threads and run a nut and bolt though it. Should still work fine that way. Cheaper then buying a new one if I don’t need it.

 

[Rttoys]

I’m assuming #3?

 

[Metal Mech]

Yes it’s number three, thank you so much.
What site is that? Probably be useful for me again in the near future.

 

[Rttoys]

That’s dealership access type stuff. I buy a bunch of stuff from the dealer, so now instead of calling it in, I can look it up myself and buy what I need. Similar to buying over the internets, but local, where I type in my po and they send it to me in a few hours.

 

[Metal Mech]

Gotcha, really appreciate the help.
Can you grab me the part numbers for the rubber pads that go on the pedals?

 

[Markm]

Those little bolts were always painful to remove. Don’t be surprised if you need a small amount of heat to help loosen up the thread locker applied at the factory

 

[Metal Mech]

Those little bolts were always painful to remove. Don’t be surprised if you need a small amount of heat to help loosen up the thread locker applied at the factory

Yeah I didn’t realize how tight they were and I was letting my kid remove it: I hadn’t taught him about how to not snap bolts yet. So learning lesson for him.

 

[Doug Rostad]

Gotcha, really appreciate the help.
Can you grab me the part numbers for the rubber pads that go on the pedals?

Dorman # 20717

 

[Rttoys]

Shoot me the vin so I can look it up properly. Doubtful it’ll be available though. Dorman is the way to go on that stuff.

 

[Metal Mech]

Shoot me the vin so I can look it up properly. Doubtful it’ll be available though. Dorman is the way to go on that stuff.

All good I went with the doorman part number posted above. I appreciate the help. Couldn’t for the life of me find it doing an online search. I ordered the screw off amazon. Also ended up ordering a new switch. I can’t get the busted screw out and ended up breaking the one trying to.
Trying to get these so I can make progress this weekend. This is one of the few weekend I’m gonna have extra time to work on the Goblin so making the most of it.

 

[Rttoys]

Ok. Cool.
You will probably have to program that brake switch. FYI

 

[Metal Mech]

Ok. Cool.
You will probably have to program that brake switch. FYI

Yuck, but not like I had a choice. Thanks for the heads up. How do I known if I need to program it?

 

[Rttoys]

When you install it and your brake lights flicker on, then off.