Nothing wrong with a HF welder...just don’t get that one. Step up to a Titanium or a Vulcan with shielding gas. I have an Omnipro 220 and it’s nicer than any other MIG welder I’ve owned. Just dial in a material thickness abs go to town.
It almost perfectly fits a 20 oz Yeti cup. I didn’t measure it but if the top was flared out a few more mm it would fit perfect.
Thanks for the tips West. I am a complete noob when it comes to 3D printing so the advice is appreciated. I’ll setup a thick wall profile and try it again sometime...
The Mayor’s new cup holder printed out great. For you total noobs out there like myself it printed fine with no supports. I went 20% infill with normal PLA and it’s got a little flex. I’ll print another one a little more solid. Here’s some pics
I like my open frame, but the bikini tops the guys have on the track frames make me jealous. I am glad I switched from easy entry that I originally ordered to a standard.
You have to throw the LE5 in the mix. Other than the tune it’s a direct replacement for the LAP and the L61 only needs to add the cam sensors to the harness or get an LAP or LE5 harness. All three share the same ECM.
When I grenade my L61 it’ll get swapped for an LE5. They are dirt cheap in...
Were the front hubs any good that you took out? If they weren’t any good the backs probably won’t be either. Don’t waste your time tearing the back axle apart. Besides the hubs you just need 8-m10x1.5 flange nuts that bolt the hubs to the spindles. I just bought new ones and left the rear put...
That sure is a nice donor! It almost takes the fun out of stripping it. Ripping and tearing at the interior with zero regard to breaking plastic clips was fun. I would think all that is sellable to someone.
Thanks for the suggestions. I just got my Ender 3 pro last night and I’ve been running it nonstop with the regular PLA I bought for it. My two year old just thinks that the blue cat and dog I printed for him are the greatest things ever!
Thank you guys all for posting your stuff and convincing...
ZZP has a full assortment of short and long blocks. The engine most people buy is from ATK. For a tranny call DF. They might still have a bunch of new ones.
I always have way better luck finding the fasteners I need at ACE hardware than at Home Depot. My stores even let you get grade 8 sae or 10.9 metric for $2.99/lb instead of paying the crazy per piece prices.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.