DPGoblin12
Member
07 Cobalt NA 2.2L
Hey guys I'm new to the forum so I apologize if I don't have something posted correctly so please be patient with me. I'll try my best to learn as I go.
I did have a question about the section of organizing the main harness part 1 at 3:20 in the video he is showing taping the body-to-engine harness to the 2 connectors that are installed in the fuse box at the time. A few seconds later he states to take the light blue wire and fold it in the opposite direction so u don't tape it with the rest. This is where I'm confused.
I have at least 2 light blue wires in that area so I'm not sure which one he is wanting to have me fold back. Is it one that is attached to a separate connector? Is it supposed to be a wire that has been thinned and separated in previous videos? If so, I don't have a light blue that is separated (hopefully I didn't mess up...)
Any help or input is greatly appreciated! Thanks!
Hey guys I'm new to the forum so I apologize if I don't have something posted correctly so please be patient with me. I'll try my best to learn as I go.
I did have a question about the section of organizing the main harness part 1 at 3:20 in the video he is showing taping the body-to-engine harness to the 2 connectors that are installed in the fuse box at the time. A few seconds later he states to take the light blue wire and fold it in the opposite direction so u don't tape it with the rest. This is where I'm confused.
I have at least 2 light blue wires in that area so I'm not sure which one he is wanting to have me fold back. Is it one that is attached to a separate connector? Is it supposed to be a wire that has been thinned and separated in previous videos? If so, I don't have a light blue that is separated (hopefully I didn't mess up...)
Any help or input is greatly appreciated! Thanks!