V1 Third brake light

[Brocker]

If you mounted a third brake light, what did you buy and how did you mount it?

 

[Joebob]

An amazon generic light (clear or red) and some 1.5" clamps. Put a little 3/4" aluminum angle to inset the light to be in line with the tubing. Brett has a ever so slightly cleaner look with his:

Brett W’s City Goblin – 09 SS Donor #229 v2.0 - Registered

Let me know if you do please. I have 2 cars already insured with them and they still won’t insure my goblin I will definitely update this thread when we get it all figured out.

dfkitcar.com

 

[Gtstorey]

Generic eBay 3rd brake/backup attached with L brackets epoxied to my heat exchanger.

 

[Brocker]

Hi Gtstorey. I live in Millbrook, near Montgomery. Did you get your goblin licensed in Alabama? Difficult?

 

[Gtstorey]

It took a little while since no one knew what needed to be done. Look in the registration section and I did a write up of the steps.

 

[k.rollin]

Chevy Colorado CHMSL attached to the top of the main hoop using 1.5" tube clamps.

 

[Robinjo]

Generic eBay 3rd brake/backup attached with L brackets epoxied to my heat exchanger.

Those are some fancy wiring looms!

 

[Rauq]

This and this:

 

[GoblinTimes]

This and this:
View attachment 32011
View attachment 32012

Can you link to the STL for that bracket? I can't find it in the STL 3d printer thread.

 

[Rauq]

Can you link to the STL for that bracket? I can't find it in the STL 3d printer thread.

Here you go!

 

[GoblinTimes]

Thabk you so much good sir!!!!

 

[JPas914]

I used one of these. Drilled two holes on the rear lip of the engine cover and epoxied two pieces of steel inside the lip to add some reinforcement for the fasteners.

 

[Goblinfanclub1234]

zip ties all the way

 

[kurbkilla]

This and this:
View attachment 32011
View attachment 32012

Did you wire both lamp and brake to power. Or just brake?

 

[Goblinfanclub1234]

I used that same light and I wired up all 3 wires, but I put the power on a plug so I can turn it off if I want to and only run 3rd brake light.

 

[Rauq]

Did you wire both lamp and brake to power. Or just brake?

If I remember correctly, everything that lights up on the running light power wire also lights up when you put power to the brake light wire. I think I just ran the Goblin harness's third brake light power wire to the brake light wire on this light and heat shrinked up the running light power wire, but I'm not sure on my recollection. Shouldn't make a difference either way.

 

[escapepilot]

I used the inexpensive ebay light and two clamps like DF supplies.

 

[finazzoty]

I’ve only got one light blue wire labeled “third brake light” coming out of the harness. Is this normal? Assuming I just connect that to the power lead on the light, and then run a ground down to somewhere. Correct?

 

[Robinjo]

Correct, but look at the diagram to see what they listed as power. Mine had black as power and white as ground. I think red was the lightly on (running lights). My ground for this was just a self-tapping screw into the bar behind the light.