V1 Turning off unwanted dash lights?

[Amack1970]

I've heard there's a thread out there with instructions on how and what to snip inside the cluster. I'd like to eliminate the abs, traction control and srs lights. Oh and the e brake light too

 

[Desert Sasqwatch]

Anthony, check out a couple threads in the Electrical section for airbag and brake light fixes.

 

[Amack1970]

I was just hunting around in there

 

[Briann1177]

http://dfkitcar.com/forum/index.php?threads/disabling-check-engine-light-cel-and-others.491/

 

[Amack1970]

I just severed those leads. The low pressure light is on, but the others are gone. Did I not get one all the way?

 

[ctuinstra]

I just severed those leads. The low pressure light is on, but the others are gone. Did I not get one all the way?

They are hard to cut all the way through. You might not have cut it completely. You might try using a meter to ohm out the connection between the two closest through holes.

Check with an ohm meter between the two holes marked in red. It should be an open circuit.

 

[Amack1970]

What do you guys know about the engine running for a couple seconds after the key is turned off?

 

[JeffsGoblin]

What do you guys know about the engine running for a couple seconds after the key is turned off?

See this thread here: http://dfkitcar.com/forum/index.php...s-sc-lsd-north-carolina.708/page-5#post-13118

 

[askiles]

What do you guys know about the engine running for a couple seconds after the key is turned off?

You need a diode spliced into the heat exchanger power. Come grab one from me, I have a handful from when I bought mine. Easy splice. Takes a few minutes.