Are you looking for fuel filler and cap or is this just on the list of things that need modify and refinishing?Updating the needs list.
Running list of items to do and figure out.
- Clutch
- clutch
throw out- resurface or replace flywheel
- fix shifter... need new plastic bushings
- master cylinder
- Engine maintenance prior to install
- rear main seal
timing setwater pump- spark plugs
- O2 sensor
- serp belt
- Fuel Filter
- Fuel cap
exhaust man studs- Drive train
- Hubs
- Bushings
- Tie rods
- axles
- output shaft seals
- Seats (NRG PVC)- would like ones that I can slide back and forth
- Lights
- Rear
- front
- parking brake
parking brake tubes- ss parking brake cables
- Rims and tires
- tires - r888 or N05
- Dash
That one is modification and part that I already ordered.Are you looking for fuel filler and cap or is this just on the list of things that need modify and refinishing?
Care to share any pics? That’s a nice spot for a custom touch.That one is modification and part that I already ordered.
Going to try and cerakote it.Care to share any pics? That’s a nice spot for a custom touch.
Not sure yet. I'm not a welder and do not know anyone that does. I would like to do the floors with diamond plate but not sure of anything else. Are you?Looks like we are running neck in neck, We will be getting our kits at the same time, Do you plan on doing any modifications to the frame?
Steel Diamond plate or aluminum?Not sure yet. I'm not a welder and do not know anyone that does. I would like to do the floors with diamond plate but not sure of anything else. Are you?
probably steel. What are these mounts you speak of?Steel Diamond plate or aluminum?
Yes, Nothing major, Few mounts here and there. You are welcome to run up here and I can do what ever you want to it. I have MIG, TIG, Plasma cutter a few different bending breaks ect.
The fuse block really needs a tab welded on to clean it up. The clamp and L bracket work good to accommodate the different fuse blocks but it doesn’t look the best.probably steel. What are these mounts you speak of?
I was thinking the same with floors and side panels... rivnuts.. easier to take off and replace if needed. only thing I haven't thought about is what to use instead of silicone to dampen the sound.I'm putting different LED tail lights on for example, Tabs for the side panels and possibly the floor so they are removable. Will prob drill holes in the tubes and fish the tail light wires through them,,, The more time I spend on this forum the more good ideas I see,
Closed cell adhesive backed foam. You can buy it from MSC by the roll in just about any widthI was thinking the same with floors and side panels... rivnuts.. easier to take off and replace if needed. only thing I haven't thought about is what to use instead of silicone to dampen the sound.