OK, thanks for the info Lonny. I will probably just solder them in but I’ll let you know for sure before you receive the harnesses. I’ll be shipping my harnesses to you today.That is odd, I can install a standard fuel pump connector on your wiring harness and you can get a new fuel pump or a used one from a salvage yard. Or I can leave the wires open and you can solder them directly to your existing pump harness.
Water driver was able to reuse the existing plug on his old fuel pump. I’m thinking of doing the same. You wired in the standard plug when you did my harness and I opened it up a little bit. I see black gray tan purple. Which is which though? I know coming out of my pump I have power, ground, and two for fuel level sensor. I assume the black and gray are power, the purple and tan are fuel level sensor. Which is power, which is ground? Is the fuel level sensor polarity sensitive?OK, thanks for the info Lonny. I will probably just solder them in but I’ll let you know for sure before you receive the harnesses. I’ll be shipping my harnesses to you today.
Thank you. After opening stuff up and looking close I was able to figure it out. I appreciate your advice on reusing the plug, it worked great. My first start went well.