V1 Lethalcast's City goblin- 2009 SS/TC G85

[Briann1177]

I should add that the BCM X4 connector is the one that plugs into the side that faces towards the front of the car. Or right against the sheet metal.

 

[Lethalcast]

It's getting closer, hopefully start it up this weekend!

 

[ctuinstra]

Looking good!

 

[Lethalcast]

Thanks Chad!

 

[Lethalcast]

Are you tc guys running the line from the intake to the back of the valve cover?

 

[Briann1177]

Yes. I cut the lines off of the existing PCV check valve and hooked it up with fuel line.

 

[Briann1177]

On a side note, I like the coated intake plumbing. Looks good.

 

[Lethalcast]

Okay I was wondering if anyone was running it. I initially thought it was the pcv but then I realized it's under vacuum. All my pieces to cut Male ends off were gone and had to cut one off a fuel filter.

 

[Lethalcast]

Thanks! I'm going for the same color scheme as my truck so the polished wasn't working for me haha.

 

[ctuinstra]

On a side note, I like the coated intake plumbing. Looks good.

Now that you mentioned it, I like it also. I'm thinking about doing the same now. Not sure if I want to paint it or what.

 

[Lethalcast]

Thanks Chad! I just got the heat sheilds back from getting cerakote and the exhaust I'll have tomorrow.

 

[Lethalcast]

How do I go about getting a baseline length for the rear adjustable coilovers?

 

[Briann1177]

Here is how I have mine set. Basically it's 4-1/4" from the lip of where the bottom lock nut goes to the top adjustment ring where the spring sits.


*Edit* Looks like the forum is having issues attaching pictures.

 

[ctuinstra]

*Edit* Looks like the forum is having issues attaching pictures.

I thought it was just me. Good to know that it's not just me.

 

[Lethalcast]

Thank you Brian! And what about total length? Just lengthen the strut shaft till the control arm is level?

 

[Briann1177]

I'm not sure what the total length is. This gives me about a 7-3/4" ride height as measured from the bottom lip of the control arm. Anywhere from 7"-8" is fine.

 

[Lethalcast]

O ya I was talking about twisting the shaft out for length

 

[Lethalcast]

Any way you could measure the total amount of the threaded part you have out.

 

[Briann1177]

Tape measure is crooked, but it should get you close.

 

[Lethalcast]

Yes it will, thank you so much. Exactly what I needed.